Steam and band tech

Mr Marnus Esterhuizen

Marnus tunes steam tunnels and dual-lane band shrink for beverage SKUs.

Mr Marnus Esterhuizen

Mr Marnus Esterhuizen tunes steam tunnels and band shrinkers on beverage lines where sleeve finish, tamper tear and dry exit matter to the shift. He works with neck bands on water, soft drink, juice and RTD packs, setting steam pressure, dwell, cut length, sleeve width, perforation position and bottle pitch until the sleeve sits square on the closure and neck.

What a normal week looks like

A typical week can move from a Band Shrink 120 start-up in a short co-pack cell to a two-lane Band Shrink 240 run, with each lane set for 120 bpm during a beverage peak. Marnus checks sleeve tray feed, bottle spacing, steam delivery and the first dry-off point, then gives setters settings they can repeat on the next flavour, cap colour or bottle size.

On compact narrow-mouth work, Marnus sets the Steam Tunnel S around the neck profile and cap skirt so the sleeve shrinks down straight and keeps the tear strip aligned. On wide-mouth packs, chemical and oil teams call him for the Steam Tunnel L, where jerry and gallon formats need slower presentation, even steam contact and controlled drying after shrink.

How Marnus works through a sleeve fault

Marnus starts a fault call at the bottle, not at the control panel. A crooked tear line points him to sleeve placement, tray friction or bottle pitch. Crow’s feet around the shoulder send him to steam pressure, dwell and sleeve lay-flat width. A band that splits at the perforation gets checked for sleeve height, perforation position, cap edge contact and whether the bottle is wobbling through the steam zone.

Condensate is treated as a process fault, not a nuisance. Marnus looks for water tracking back onto caps, dripping from the hood, pooling near guides or reaching the next handling point while sleeves are still warm. He then adjusts drain paths, hood seals, steam balance and drying air so the pack exits clean enough for manual handling, tray packing or coding.

Fit notes for setters and maintenance leads

For 28 mm, 33 mm, 38 mm and 45 mm beverage neck finishes, Marnus checks the sleeve against the actual cap and bottle sample on the line. He measures the sleeve height, confirms the tear perforation faces the operator’s opening direction, and watches several bottles through the tunnel before changing speed. Maintenance leads get practical notes on gasket wear, sleeve dust, guide rub marks, sticky tray surfaces and steam traps that change shrink from one shift to the next.

When to ask for Marnus by name

Ask for Marnus when a sleeve job has to run at production tempo rather than trial pace, when two lanes must match, or when a new beverage SKU gives different shrink on the shoulder, cap skirt or tamper band. He is also the right person for handover after a sleeve size change, a steam hood service, or a drying problem that keeps coming back.

Plant teams can book Marnus through our contact form when bottle, cap and sleeve samples need a shrink setting checked before the next run. For line layout, co-pack planning or audit handover, Marnus works with the wider technical team so the steam cell fits the plant’s daily changeovers.

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston