Band Shrink 240
The Band Shrink 240 is a dual-lane steam band shrinker for capped beverage bottles. Each lane runs at 120 bpm, giving 240 bpm combined through one steam manifold, with steam plus 4.0 kW on the machine. Setters adjust lay-flat to the closure, set cut-band drop, balance steam pressure against dwell, hold bottle pitch steady and give the exit enough drying travel for a clean tamper band.
It suits high-volume water, soft drink and RTD plants where two bottle streams share one neck-band format. Typical fits are a Bellville water plant running 28 mm closures, a Gqeberha beverage co-packer moving mixed flavours, or a Stellenbosch RTD line where the tear perforation must sit neatly on the cap skirt.
Where it sits in the beverage line
The machine sits after capping, once every bottle has a square cap and steady shoulder. Side guides centre each bottle into its sleeve lane, and pitch must be regular enough for cut bands to present squarely. For lane hardware and magazine handover, see the sleeve feed tray notes.
After steam, bottles need drain and drying travel so condensate is off the cap, shoulder and sleeve edge before coding, labelling or carton packing. Chilled packs need closer exit checks because bottle sweat can look like steam carry-over. Operators check that the lower sleeve edge grips below the tamper band without riding up.
What the first shift looks like
The first shift starts with capped bottles, sleeve bundles and the planned bottle pitch. Setters measure the flat sleeve, compare it with the closed neck and check that the cut band will sit without stretch marks. Sleeve drop is adjusted so the tear line lands at the pull point on the cap skirt. The two lanes are centred, guides are locked, and steam is brought up gradually while the first bottles are watched at the exit.
Early checks are practical: no twisted bands, no fish-mouth openings at the lower edge, no split perforation, no cloudy over-shrink on the cap top and no sleeve climbing at steam exit. Dwell is tuned by line pace, then trimmed with pressure. The Band Shrink 240 specs cover format and utility points.
Maintenance points and shrink faults
Daily care is centred on steam quality and water removal. Drain condensate from the steam path, wipe sleeve guides, check the hood seal gasket, clear blocked jet points and confirm both lanes receive even steam. A wet exit, one hot lane and one lazy lane usually points to condensate, blocked steam delivery or guide misalignment.
If bands tear during shrink, the sleeve may be too tight, too tall, or sitting with the perforation across a cap feature. If the band is loose below the cap skirt, lay-flat width or dwell needs correction. If drying is the issue, add exit air or more open travel after steam. Planned wear checks are covered under Band Shrink 240 service.
Fit notes for other formats
For one beverage lane, pilot packing or a moderate co-pack cell, the Band Shrink 120 gives the same steam-and-sleeve method on one lane, with less floor width and simpler changeover. It suits plants that run one bottle stream at a time and want one sleeve magazine, one guide set and one drying path.
For large-neck jerry cans, gallon containers and bigger chemical or edible oil packs, the Steam Tunnel L gives the extra container clearance and steam chamber space those formats need. Band Shrink 240 suits high-volume beverage neck bands where two bottle lanes share one steam manifold. When comparing machines, use capped samples, the printed sleeve roll and the planned bottle pitch so sleeve height, shrink finish and exit drying can be checked together.
| Rate band | Up to 240 bpm combined |
|---|---|
| Power / utilities | Steam + 4.0 kW |
| Neck / format | Twin sleeve lanes |
What our Bottle Sealing customers say
Verified Google reviews

