Rails
Rails and fixtures
Hardware that keeps sealing cells square and repeatable on existing conveyors.
Rails and fixtures
These are hardware accessories, not full sealers. The foil tray is a Foil and Die Kit changeover insert that never sits in the seal path; the reject pocket clears a miss without knocking good bottles.
Standard guide rail
Adjustable side guides for PET and HDPE on 1.5 to 3 m cells.
Details
Reject pocket
Air-blast reject pocket timed to vision and foil miss signals.
Details
Coil mount bracket
Height-indexed coil mount for summer PET adjustments.
Details
Steam hood seal
Hood gasket set for Steam Tunnel S and L chambers.
Details
Sleeve feed tray
Band sleeve tray geometry for 120 and 240 lanes.
Details
Torque head pad
Replaceable pads for Cap Torque Station recipes.
Details
Vision light bar
LED bar spares for Seal Inspect Vision tunnels.
Details
Wand stand
Bench stand for Manual Hand Sealer between batches.
Details
Sensor kit
Photo-eye and encoder spares on integration rails.
Details
Foil tray
Die and foil tray insert for Foil & Die Kit changeovers.
DetailsChoosing rails and fixtures for an existing line
Most sealing cells we fit go onto conveyors that were already running, so the rail and fixture side matters as much as the sealer. Guide rails keep the bottle square under the coil or inside the steam tunnel. A crooked bottle gives an uneven gap to the foil and a partial seal, or a band that sits high on one side.
Start with the bottle drawing and a photo of the conveyor where the cell will go. Note the belt width, pitch between bottles and where rejects can drop without blocking the next station. The coil mount, sensor kit and reject pocket are sized from those numbers, and the foil tray and sleeve feed tray only matter at changeover.
Spare torque pads and steam hood gaskets wear on a schedule, so it pays to keep one set in the plant. Bheki can put the right parts on a quarterly spares card for you.
