Steam Tunnel L
Steam Tunnel L handles steam shrinking for jerry cans and gallon containers where a tamper sleeve must tighten over a large cap, neck bead and upper neck. The setter works with steam pressure, dwell and bottle pitch, then watches how the sleeve pulls over the cap skirt. A good pack shows a straight tear perforation, neat top edge and no loose band below the bead.
The tunnel sits after capping and sleeve placement, with the container travelling upright into the steam chamber. Before steam, the sleeve must match the neck diameter, sit at the right height and miss the shoulder guides. After the tunnel, the pack needs drip-off time, because handle pockets, broad shoulders and oily surfaces can carry condensate into coding, labels or cartons.
Packing situations it suits
A Wadeville household chemical plant packing 5 litre cleaners often has moulded handles, heavy filled containers and mixed jerry profiles on one conveyor. The larger chamber gives line setters space to shrink bands around broad caps while keeping the container upright through the steam zone. Body guides should hold the container square so the tear line stays on the opening edge.
On an edible oil line in Isando or Germiston, gallon containers bring glossy shoulders and cap areas that show every water mark. The steam pattern should grip the top of the sleeve first, then finish the lower edge without dragging the band down the taper. After oil clean-up, watch for sleeve movement on slippery shoulders before shrink is complete.
A Richards Bay chemical filler running larger jerry packs may spend more time on bottle pitch than line speed. Heavy containers can bunch at transfers, changing dwell through the chamber. When two packs enter too close together, steam exposure changes around the sides, and the lower edge can wrinkle on one container while the next one looks right.
First shift on the floor
The first shift starts with a sample sleeve, a capped container and a set position where the tear line sits cleanly on the opening edge. Bring the steam up to working condition, centre the pack path and run a small group through at a controlled pace. Checks are direct: square sleeve, readable tear perforation, no dog-ears and no cooked-looking lower edge.
Once production is moving, record steam pressure, dwell, guide width, bottle pitch and sleeve batch. If the sleeve is skew after steam, look upstream at the sleeve stack, cut quality, placement and shoulder contact on the guide. If the sleeve is square but wavy at the base, balance pressure and dwell so the cap area shrinks firmly without overworking the shoulder.
Condensate and maintenance checks
On large handled containers, condensate collects in places a round bottle never gives you: under carry handles, in moulded grip pockets and along broad shoulders. It can then drip during coding, cartoning or palletising. Keep drain paths open, fit drip collection where the layout needs it and use a short drying gap after steam. Wipe oil film from rails before judging shrink quality.
Maintenance checks should follow the sleeve result. Inspect the hood gasket, steam distribution, drains, guide clamps and belt tracking after every container changeover. A damaged gasket can give a tight sleeve on one side and a loose edge on the other. A blocked drain pushes moisture back into the chamber. For gasket sets, steam distribution checks and chamber work on larger handled packs, use Steam Tunnel L service.
Model fit notes
Choose Steam Tunnel L when production is finishing sleeve bands around a large closure, upper neck and shoulder on a jerry or gallon container. For narrow-mouth bottles in a compact cell, Steam Tunnel S gives a smaller steam chamber with a tighter sleeve path. Where the line also needs sleeve cutting and placement ahead of steam finish, Band Shrink 120 matches a single-lane band process.
Plants running paired sleeve lanes can look at Band Shrink 240, then size drying space around the actual pack shape. For Steam Tunnel L layout, container envelope, utility planning and guarding notes, see Steam Tunnel L specs. Sample sleeves, cap photos and filled-container measurements can be checked against chamber clearance, sleeve height and drying space in Meadowdale Industrial, Germiston.
| Rate band | Up to 60 bpm |
|---|---|
| Power / utilities | Wide steam |
| Neck / format | Jerry and gallon |
What our Bottle Sealing customers say
Verified Google reviews

