Seal craft

Seal integrity habits that survive a real shift

How BottleSealer keeps foil, band, and torque checks consistent on South African co-pack floors.

Craft means the seal holds after the cooler

Seal craft is the shop-floor habit of making the same pack seal at start-up, after lunch, after a capper stoppage and during the last pallet. For induction work, the setter records power, line speed, induction head height, cap torque, neck finish and foil wad batch. For band work, the card records sleeve width, steam pressure, bottle pitch, tear line and drying point.

A first-off sample belongs at the start of every run and after every stoppage that touches caps, foils, sleeves or steam. Mark it with time, SKU, setter and setting. The line then runs against that proof, not memory. A note on the seal check card gives maintenance and QA the same facts when a weak peel, wet sleeve or crooked band appears later.

Settings that stay with the machine

A line card should sit at the machine. For foil sealing it lists cap torque, induction head position, belt pace, foil type, neck size and the first-off result. For sleeve sealing it lists lay-flat width, cut height, steam pressure, lane, pitch and the pack position where drying is checked. Add restart steps after a power cut or jam clearance.

On the Seal Induction Pro, a useful record tells the setter what worked on PET or HDPE, which cap was fitted and how the aluminium liner sat on the bottle land. A trial station such as the benchtop Seal Induction Compact gives craft teams up to 25 bpm for sample runs, and its notebook should use production-style entries because those notes often become the recipe. Buyers comparing full cells can use the sealer range for the rest.

One change at a time

When seals drift, the setter changes one variable, runs enough bottles to see the effect, then writes down the result. Changing speed, torque and foils in the same five minutes creates arguments instead of answers. For induction work, the change might be torque, head height or speed. For band work, it might be steam pressure, tunnel dwell, sleeve height or bottle spacing.

Band checks need the same patience. With Band Shrink 240, the machine gives two lanes at 120 bpm each; each side needs its own first-off and fault note. Lane one might show a neat tear line while lane two pulls the sleeve low on one shoulder. Mark the lane, mark the time and adjust only the cause being tested.

Handover notes that keep the next shift on track

A good handover note says what was changed, why it was changed and what the next operator must watch. “Runs fine” gives the next shift nothing. “Torque increased one mark after loose caps at 11:20; first-off passed; recheck at pallet 3” can be acted on. Attach the handover template to the job pack so the next setter sees the same evidence as QA.

The line card should carry the neck finish, cap supplier, foil wad, sleeve batch, capper setting, sealer setting, steam start check, reject count and first-off sample location. Add a maintenance note for belt rub, guide scuff, sensor knock, steam hood drip, loose guard or cap feed issue. These small comments stop the fitter from chasing a seal fault that began as a mechanical bump upstream.

Faults the pack is already showing

A foil that peels in patches often points to uneven cap pressure, a liner that shifted in the cap, a wet bottle land, or a head height setting that moved during cleaning. A band that twists usually starts with sleeve lay-flat, bottle pitch or rail contact. A sleeve that looks sharp when hot and slack after packing needs a drying and cooling check at carton close. For a craft review, pack one good sample and one failed sample from the same run with the setting card, so the difference can be checked against the cap, liner or sleeve batch rather than opinion.

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston