Resource

Handoff template

Template for commissioning handoffs sent through our contact form.

Gloved hand passing a blank clipboard across a steel packing bench, white HDPE bottles behind

Handoff template

The handoff template is used when a new sealing or banding job moves from quote and trial notes into commissioning. Plant managers use it to name the product and pack, line setters confirm the neck or sleeve data, and maintenance leads prepare access, air, steam, power and spares. Keep the finished template in one message through our contact form and name the plant contact in the subject line.

Start with site details: plant town, production line name, SKU or product family, bottle material, pack size in litre or millilitre, cap type and the person authorised to sign off. Add the shift window for trials and any washdown restriction. For a retrofit, attach a marked layout or use the retrofit bay sketch to show capper, conveyor, operator side and open floor space.

Pack, neck and cap entries

Next, record the neck finish as 28, 33, 38 or 45 mm and state whether the pack uses induction foil wads or shrink sleeves. For foil work, note the cap supplier, liner stack, bottle land condition and target packs per minute. The foil neck chart gives the setter one confirmed neck reference when several closures run on the same product.

Enter the cap torque target after the capper has been checked with sample bottles, not from an old recipe name. A loose cap can give patchy bonding; too much torque can ovalise light caps, mark the thread and make a damaged bottle land look acceptable during a quick check. Link the handoff to the torque recipe sheet where more than one cap, fragrance or oil grade runs on the same capping head.

Sleeve and steam entries

For shrink band work, record the cut height, the sleeve’s flat measured width, the outside neck size, the tamper-tear position and the bottle spacing planned at the applicator. Add the sleeve artwork orientation if the tear line must face a label panel. The band sleeve size chart gives the buyer and setter a shared reference before sample sleeves are ordered for stepped shoulders or tall caps.

Attachments and worked example

The attachment list is part of the tool. Add three cap or neck photographs: side view, top land view and closure underside. Attach the line layout, a short video of containers entering and leaving the capper, and any QA record. For induction projects, include sample results from the seal check card so bond condition, foil placement and wet-test notes reach the commissioning team early.

A worked entry would read: Germiston sauce line, 500 millilitre PET, 38 mm flip-top cap, induction foil wads, target 80 bottles per minute, sign-off by the production manager on day shift. Cap torque has been set from the current recipe sheet, neck photographs are attached, and the layout shows the sealer position between the capper outfeed and existing accumulation table.

Fit notes and common mistakes

Use the maintenance notes to state access side, guard constraints, cable route, steam drain point, air take-off and where operators stand during start-up. Mention changeover tools kept with the line and the person who owns first-level cleaning after a trial. Spanners, sleeve samples, foil wads and test bottles can then arrive with the right people.

Before sending, check for blanks that slow commissioning: no plant town, no sign-off contact, neck finish guessed from cap colour, sleeve width copied from a different bottle, cap torque left as 'standard', photos taken with the cap on, or layout sketches with no direction of travel. Book commissioning support once those blanks are closed, so the commissioning visit starts from confirmed pack data rather than a recipe hunt on the line.

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston