Resource
Seal check card
One-page export week seal checklist for the line lead.
Seal check card
The Seal Check Card is a one-page shift record for export induction sealing runs. The line lead uses it at start-up, after stoppages, after changeovers and after capper or liner adjustment. It records what was tested while bottles were moving, so cartons are released with dated seal evidence rather than memory or verbal handover notes.
Use the card on PET and HDPE bottles with 28, 33, 38 and 45 mm neck finishes. It suits continuous lines running Seal Induction Pro, and it also gives short export batches a written check route on Seal Induction Compact for sauces, edible oils, syrups, supplements and household chemicals.
Fill it in from the top down
Start with date, shift, line number, product name, pack size, bottle material and neck finish. Add cap type, liner batch and foil reference, then compare the neck to the foil neck chart. This catches mixed caps or a wrong wad before scrap builds up.
Next record the sealer name, power setting, belt speed, cap torque and the height mark used on the sealing head bracket. Torque is written down because cap pressure holds the wad flat on the neck land while the heat-seal layer bonds. If the plant has a capper recipe, copy the target from the torque recipe sheet.
Run the checks in order
The check section follows the bottle in your hand: foil position, visible wrinkles, incomplete seal area, peel result and leak result. Add the sample time for each test. After a power cut, a foil carton change, capper reset or bottle batch change, start a new entry on the card.
Foil position tells you whether the liner sat squarely under the cap. Off-centre foil points to mixed caps, liner handling damage or cap chute trouble. Wrinkles point to a pinched liner, rough bottle land or torque drift during the shift. Write the likely area beside the failed sample time.
Worked entry from an export shift
A filled entry might read: Tuesday night shift, export chutney, 500 ml PET, 38 mm neck, white ribbed cap, liner batch F38-07, Seal Induction Pro. The setter records the running panel settings, head height from the indexed bracket and cap torque after the capper has warmed up.
At 19:20 the lead opens ten bottles. Nine foils sit centred and flat; one has a crescent wrinkle near the rim. Five peel tests show an even pull across the land. The suspect bottle leaks on inversion, so the capper is adjusted. Five fresh samples at 19:32 pass, and the release is signed.
Common mistakes with the card
The first mistake is writing one “OK” for a whole shift. Export runs need time-stamped checks, especially after stops and changeovers. The second is leaving torque blank because the top looks neat. A neat foil can still leak when cap pressure was low during bonding.
Another mistake is mixing visual checks, peel tests and leak tests in one comment. Keep them separate so maintenance can trace the failure. If the same fault repeats, keep failed samples with the card and note the pack size, neck finish and bottle supplier.
Do not hide an incomplete seal behind a tick. Write “open at 3 o’clock”, “thin bond on rail side” or “burnt edge on two samples”. Seal Inspect Vision gives an in-line reject record for bottles with no foil present, while the card records the opened-bottle evidence that export release depends on.
