Line

Chemical drums

Jerry and small drum formats on chemical packing with wide steam tunnels.

Primary sealer: Steam Tunnel L

Chemical jerry and small drum formats at a wide steam tunnel

Chemical drums

Chemical jerry cans, gallon packs and small HDPE drums carry wide caps, broad shoulders and moulded handles, so the tamper sleeve has to shrink evenly around more plastic than a narrow bottle neck. South African chemical plants run cleaners, pool products, solvents, detergents and agrochemical packs where necks may reach the sleeve station with splash marks, foam residue or cap wetness. BottleSealer recommends the Steam Tunnel L for these wide-mouth formats because the steam space suits jerry shoulders and taller cap profiles.

Packs, closures and sleeve fit

The closure area on a 1 litre to 5 litre jerry pack is usually squat, with a flat screw cap sitting close to a raised shoulder. Sleeve lay-flat width must match that shape, not only the cap diameter. A sleeve that is too tight drags on the cap edge and splits at the tear line; a loose sleeve twists when steam hits it. The sleeve height is set so the perforation tears cleanly while still covering the cap skirt and upper neck.

Line sequence from filler to cartons

The normal chemical drum sequence is fill, cap, wipe, sleeve placement, steam shrink, drip control, drying, label application, date coding and case packing. At the sleeve station, bottle pitch matters because jerries with handles can disturb one another if shoulders touch on the belt. Guides should hold the body square while leaving the sleeve area open to steam. Where automatic sleeve presentation is used ahead of the tunnel, the Band Shrink 120 can feed consistent cut bands into the same packing flow.

Steam settings and the failures they prevent

Most chemical sleeve faults start with wet plastic, poor sleeve sizing or rushed dwell. Chemical residue on the neck reduces sleeve grip, so the sleeve creeps upward and shrinks above the cap skirt. Too much steam pressure can make the lower edge curl on wide shoulders; too little produces soft wrinkles at the rear of the cap. Short dwell shows up as a loose band after cooling. Condensate collects in handle recesses and shoulder pockets, so the dry-off length after the tunnel must suit the pack shape.

Maintenance and fit checks on wide-mouth runs

Line setters should check sleeve height, tear perforation position, bottle pitch and steam pressure at every changeover, then run capped samples through the tunnel at production spacing. Maintenance crews clean condensate paths, inspect steam nozzles, check belt tracking and replace the steam hood seal when vapour escapes around the hood instead of working on the sleeve. The sleeve feed tray should match the sleeve stack so operators are not fighting skewed bands during the run.

Typical customer situation

A Gauteng toll packer running 5 litre chemical jerries asked for a sleeve cell after cartons were arriving damp and tamper bands were riding high on one shoulder. The set-up started with a neck wipe, corrected sleeve lay-flat width, a lower sleeve position and wider bottle pitch through the Steam Tunnel L. Steam pressure was set to shrink the cap area without flooding the handle recesses, then the drying gap was extended before labelling and cartons. For sample packs and sleeve trials, bring containers, caps and sleeve stock to the counter in Meadowdale Industrial, Germiston, or send a message through our contact form.

What our Bottle Sealing customers say

Verified Google reviews

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston