2026-09-21
Audit photo card for seals
A one-page photo habit that retail auditors actually read.
Audit photo card for seals
Retail seal rejections become costly when the note says only “bad seal” or “loose band”. The audit photo card gives the auditor, setter and QA sampler the same picture reference for 28 mm, 33 mm, 38 mm and 45 mm neck finishes. It names partial foil, wrinkle under cap, skew sleeve, off-centre perforation and cap alignment out of square.
The card sits at the seal check point with current samples from the run. A bottle is held next to accepted and rejected photos, then the matching fault name goes on the hold label. Ms Lesedi Molapo’s seal quality work uses this short visual habit for export weeks and retail audit queries. See Ms Lesedi Molapo.
Why the fault name matters on South African lines
Local packing floors change formats quickly. A co-packer may run a 38 mm PET sauce bottle in the morning and a 33 mm HDPE product after lunch, with different caps, liners and artwork. Without the card, a buyer’s note can mix cap torque, foil placement and sleeve position into one complaint.
Sleeve work needs the same discipline. On a Band Shrink 120 job, the card can separate a sleeve sitting high from a tear line that has moved off centre. The setter then compares the named fault with the sleeve roll width, cut length, bottle spacing through the steamer, time under steam and any water marking on the pack.
A floor method that takes one minute
At start-up, place three signed good bottles beside the audit photo card. They must match the SKU, cap colour, neck finish and sleeve artwork for that run. QA checks first-off bottles at the Seal Induction Pro outfeed for foil coverage across the bottle land, cap alignment and edge wrinkles.
During the run, pull samples after every cap change, liner change, sleeve roll change and restart. Hold any suspect bottle next to the rejected photos and choose one fault name. If Seal Inspect Vision is fitted, its reject record can be paired with the same photo-card term.
What to record in the journal
Each journal entry should show date, time, SKU, neck finish, cap lot, liner lot, operator, cap torque setting, induction sealer height reference on the machine scale and the photo-card fault name. Sleeve entries add the roll code, sleeve width, cut length, tear-line position, steam setting, spacing between bottles and any visible water marking. A printed seal check card keeps these items together for shift handover.
Keep the audit photo card clean and current. Replace the picture set when a new cap profile, liner source, bottle neck or sleeve artwork becomes regular production. Old photos create false passes, especially when the cap colour or tear strip has changed. Store the card flat in a wipe-clean sleeve at the inspection point.
Worked example: condiment bottle audit
A Gauteng condiment line packs a 38 mm HDPE bottle with an induction foil liner and a tamper band. A retail counter holds three bottles for “seal failure”. The auditor uses the card and finds two faults: one foil not covering the bottle land and two sleeves with the perforation line off centre.
The journal records the cap lot, liner lot, sleeve roll, torque setting, sealer height reference, steam setting and both fault names. QA checks the capper and liner feed, followed by the sleeve tray and steam dwell. After adjustment, the next samples get a peel pull, cap-off sight check and inverted leak hold. For recurring audit wording disputes, send the bottle photos, journal line and fault names through our contact form for review against the card terms.
What our Bottle Sealing customers say
Verified Google reviews
