2026-09-12

Dairy heat budget on thin walls

Compact induction settings that respect cultured dairy bottles.

By Mr Johan van Wyk · Sealer commissioning

Cultured dairy bottles with careful compact induction heat

Dairy heat budget on thin walls

A dairy heat budget is the sealing heat a capped bottle can take before the finish softens, the mouth goes oval or the cap skirt starts to mark the pack. On thin-walled cultured dairy packs, 28 mm drinking yoghurt necks and 33 mm cultured cream necks show trouble first at the cap skirt: oval mouths, wrinkled liners, wet leaks after cooling, or a cap sitting off-square on the sealing lip.

On South African dairy lines, this shows up when short SKU runs meet warm packing rooms, mixed bottle lots and fast capper changes. A cultured dairy bottle can arrive light, freshly blown and soft at the shoulder. If cap torque is high and the induction setting is copied from a heavier bottle, the neck is squeezed while the foil bonds.

Set the pack before setting the heat

Start with the capped sample, not the sealer knob. Confirm the resin, neck drawing, cap, liner construction and whether the pack is filled warm, chilled or at room temperature. Set cap application first, using the plant capper or a Cap Torque Station where recipes are being built. The liner must lie flat, the cap must land level, and the bottle must not rub at the neck.

Run a short bench trial on the Seal Induction Compact. Begin with a conservative heat setting, a steady bench pace and a measured head height above the cap. After each change, open samples at the same cooling time. Open the bottle and read the mouth: the foil should carry an even ring at the sealing lip, with no dragged aluminium, no melted edge and no cap skirt distortion.

Use one adjustment at a time

Change one variable between sample sets. If the liner lifts cleanly from one side, improve cap contact or add a small amount of sealing heat. If the bottle mouth turns oval, reduce heat exposure or speed the pass slightly. If the foil centre colours while the outside edge stays loose, check cap seating and liner match before adding power.

Record the working window on a seal check card: bottle supplier and lot, neck size, cap and liner description, torque setting, Compact power, belt setting, head height, sample time, cooling time and the result after opening and leak testing. Add notes for warm-room starts, Monday start-ups and restarts after a stoppage.

Liners, fit and maintenance notes

Match the dairy liner to the exact neck drawing, not only the nominal 28 mm or 33 mm size. Use the Foil & Die Kit for induction foil wads and changeover dies for common dairy necks, including 28 mm and 33 mm. A wad cut a fraction small can leave a moon-shaped wet track; a wad cut too large can buckle under the closure and still look neat from above.

On the machine, keep the belt clean, guides square and sensors free of milk mist and cap dust. Check that capped bottles stand upright under the head and do not bounce as they enter the sealing zone. For longer dairy runs moved from bench approval to conveyor work, a Line Integration Rail gives set guide positions, trigger points and space for rejected bottles around the approved bottle pitch.

Worked example: thin 28 mm drinking yoghurt

A typical 28 mm drinking yoghurt trial starts with capped bottles from the filler, the actual liner batch and the capper torque already set. The first Compact run uses low heat and a steady hand-fed pace. The foil shows a partial edge bond, so torque seating is checked before heat is raised. The next set seals fully, but two necks show skirt whitening, so heat is trimmed back.

The final record lists the lower setting, cap torque, liner batch and cooling time used for checks. Operators pull first samples after breaks and after any bottle supplier change. Sample packs for approval should be labelled by bottle lot, cap lot, liner lot and fill condition, then opened at the same cooling interval used in the recorded heat budget.

What our Bottle Sealing customers say

Verified Google reviews

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston