Support

Training

Short operator and maintenance sessions.

Training sessions at Meadowdale cover first-seal photos, reject timing twice, and wall-card updates when foil lots change. Compact cells often train recipes before operators move to continuous Pro lines.

Training support

Training is booked for the crew that actually touches the sealing or shrinking cell: operators, line setters, maintenance fitters, QA checkers and the shift lead who signs off first-off packs. Sessions run at the counter in Meadowdale Industrial, Germiston, or at your plant with your own bottles, caps, liners, sleeves and reject hardware in use.

Start through our contact form with the plant address, preferred dates, pack list, neck sizes, cap and liner type, sleeve size, current fault photos and the names of the people attending. Include short videos of the line stopping, rejecting late, scuffing sleeves or making weak seals. That gives the trainer the right pack sequence for the session.

Who attends and what each group practises

Operators practise safe start-up, pack presentation, cap seating, sleeve handling, first-off sampling and stop-start recovery after a break in production. On induction sessions they may train on a Seal Induction Compact cell for recipe discipline before moving the same pack logic onto a Seal Induction Pro line.

Fitters work deeper into set-up: guide position, sensor position, reject timing, belt tracking, steam hood checks, air blast aim and the handover points that keep night shift from guessing. QA staff work with the setter on sample selection, first-seal photos, batch notes and the seal check card used at the line.

Order of a training session

The session starts with safety around moving belts, hot steam areas, compressed air, isolation points and safe pack removal. The trainer then walks the crew through the pack path from infeed to reject pocket, naming each adjustment that the setter may touch and each adjustment that stays with maintenance. This stops casual knob-turning during a busy run.

Setting comes next. The crew sets bottle guides, pack pitch, cap torque reference, induction head height, power setting or steam dwell, depending on the cell. First-off packs are run slowly, photographed and marked. Reject timing is checked twice: once at the first test and again after the line has settled under normal handling.

Faults covered on the floor

Induction faults are taught from the pack, not from theory. The crew reads signs such as a loose cap, wet bottle land, damaged liner, wrong neck finish, under-heated aluminium or a cap applied off-centre. Operators learn when to stop and call the setter; fitters learn where to look before changing recipe values.

Steam band sessions cover sleeve lay-flat width, sleeve height, tear line position, steam pressure, bottle spacing, condensate, drying and lane balance. On Band Shrink 240, the crew treats each lane as its own 120 bpm line while watching the shared steam supply. Training includes skewed bands, wrinkles, split perforations and wet packs after the tunnel.

Handover after training

At the end, each trainee receives a marked handover card showing the pack used, accepted settings, reject timing note, first-seal photos and checks to repeat after a product or foil-lot change. The shift lead keeps the signed attendance list and the wall-card changes agreed during the session.

Maintenance receives a short action list for worn guides, damaged sensors, belt tracking, steam leaks, loose brackets and spares to order. If the line has mixed crews, the trainer can base the final sign-off on the handoff template so day shift, night shift and weekend crews use the same wording.

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston