Somerset West

Somerset West CBD oils

Foil kits and quiet torque for wellness oils.

Somerset West CBD oil bottles with foil kits and quiet torque

Somerset West CBD oils

The Somerset West job was on a CBD and wellness oils line filling small glass and PET bottles in short batches. Regular packs used 28 mm and 33 mm neck finishes, with larger closures kept for selected oil formats. The job started after operators spent too much time matching aluminium liners to caps and resetting torque by feel.

The brief matched a practical CBD oils line: keep the small bottles upright, close child-resistant caps without cracked closures, press the liner flat onto the bottle land, then seal at a pace the team could repeat. The plant wanted clear changeover notes for moves between 28 mm PET and 33 mm glass runs.

Survey and set-up sequence

During the Somerset West survey, filled samples were walked from filler discharge to the capper, then through sealing and final inspection. Bottle pitch, capper exit stability, guide contact and straight conveyor length were checked with filled samples from the Somerset West line. The smaller oil packs were matched to a Foil & Die Kit, with each die marked against its cap family.

Set-up started at the capper because torque decides how well the liner sits on the bottle land. Recipes were loaded on the Cap Torque Station for child-resistant caps, tamper-evident caps and larger oil closures. Each recipe was checked with filled bottles, so the setter could hear cap contact and see cap level.

After the capper ran steadily, the Seal Induction Pro was set to the plant’s normal running pace and adjusted against peel samples from the actual CBD oil bottles. Head height, power setting and belt pace were recorded for each neck finish. The guide rails were tightened just enough to control bottle travel.

Fault found during commissioning

The first 28 mm PET run gave clean, even peel results, but the first 33 mm glass run showed weak peel on one side of some bottles. The pattern followed a cap change and appeared more often after a short stop-start. The aluminium liner was present, the cap had seated, and the bottle land was clean.

The setting had been copied from the smaller child-resistant cap and saved under the 33 mm glass run during a rushed trial. That lower torque left the liner pressed unevenly after stoppages. The team reset the recipe, changed the torque head pad to suit the closure face, and updated the changeover sheet.

Inspection and daily running

The Somerset West line now runs CBD oil batches at the agreed production pace, with the setter calling up the cap recipe before filled bottles reach the capper. Start-up samples are pulled after warm-up, after every bottle or cap change, and after longer stoppages. Seal Inspect Vision rejects bottles where the liner is absent, skewed under the cap, or not fully bonded on the neck finish.

The line team looks after the cell through short, repeatable checks. Operators confirm the correct die, liner stack, cap recipe and sample result while the first filled bottles are still being watched. Maintenance checks capper pads, belt condition, sensor position, reject timing and recorded settings. Spare wear parts stay with the line file for planned oil runs.

Fit notes for similar oil plants

This Somerset West project suits plants that change between small oil bottles often and need the capper and foil selection to move together. The lesson from the fault was plain: a neat seal starts with the correct cap pressure before heat is applied to the liner. For a repeat Somerset-style installation, sample packs should include the smallest PET bottle, the tallest glass bottle, every closure family and liners from the actual cap supply.

What our Bottle Sealing customers say

Verified Google reviews

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston