Resource
Band sleeve sizes
Common sleeve heights for beverage and nutra.
Band sleeve sizes
The band sleeve size card is used by line setters, plant managers and maintenance leads when a beverage neck band or nutra tub sleeve changes height, material, bottle shape or supplier. It records the measurements that affect how the sleeve sits before steam, how long it sees heat, where the tear perforation lands and how dry the pack is after the tunnel. A good entry gives the next shift a repeatable starting point, not a guess from the last run.
Use the card during first-off trials, new artwork approval, seasonal pack changes and after a bottle or cap mould change. It suits sleeve work on Band Shrink 120, dual-lane Band Shrink 240, narrow-mouth finishing through Steam Tunnel S and wide-mouth jerry or gallon work through Steam Tunnel L. For beverage and nutra packs, common sleeve heights sit around 40 to 130 mm, depending on coverage and tear access.
Complete the size entry in order
Start with the SKU name, bottle size, cap finish and container shape. Add the sleeve material, then measure lay-flat width from the actual cut sleeve, not from artwork. Fit one sleeve by hand and note whether it slides freely over the closure and neck without rocking. Record the neck diameter, cap diameter, shoulder start and any bead or grip panel that can catch the sleeve during placement.
Next enter sleeve height from the cut edge to cut edge, then mark where the tear perforation sits against the cap skirt, neck ring or shoulder. Add bottle pitch in millimetres as it runs on the belt, because close spacing can steal steam from one side of the pack. Record steam pressure, dwell setting, belt rate used for the trial, condensate seen at the hood or drain, and the drying setting used before coding, labelling or packing.
Worked example of a completed entry
A nutra line running a 500 ml round tub records a 38 mm cap, straight shoulder, PET-G sleeve, 72 mm sleeve height and tear perforation aligned 4 mm below the cap skirt. The setter notes a snug lay-flat width with free sleeve drop, 95 mm bottle pitch, medium steam pressure and a dwell setting that closes the sleeve evenly under the cap without whitening. The entry also says the drain was clear, the exit air dried the shoulder, and the first tray of samples showed no skew.
Common mistakes on band sleeve sizes
The most common mistake is measuring the cap and ignoring the shoulder. A sleeve that clears the cap can still snag on a bead, oval panel or rib. The next mistake is choosing sleeve height from artwork space instead of shrink behaviour, which can put the lower edge on a curved shoulder and create a smile. Other traps are placing the tear perforation on a seam, setting bottle pitch too tight, using extra steam pressure to hide poor fit, and accepting wet shoulders after the tunnel.
Fit, steam and upkeep notes
Keep the sizing card beside the steam start sheet so pressure, dwell and drying changes are written down during the run, not remembered after stoppage. Check the steam hood seal for leaks, drain condensate before sampling, and clean scale from nozzles when shrink bands start showing dull patches on one side. Sleeve stack angle and pick height matter as well; the sleeve feed tray should present each cut sleeve square to the bottle pitch. For trials, bring samples to the counter in Meadowdale Industrial, Germiston, or email the completed card through our contact form.
