Cap Torque Station service
The Cap Torque Station needs a set care routine because cap torque affects leaks, induction seal contact and customer opening feel. On sauce, oil, chemical and pharma syrup lines, trouble often starts with dirty cap contact faces, mixed closure batches, rushed recipe changes and poor restart practice after stoppages. A clean service programme keeps the capper steady from the first bottle after start-up.
Service cadence on the line
Each shift, the setter should match the loaded recipe to the cap and bottle in production, then record set torque, actual torque from a hand tester and closure type. Wipe product mist, cap dust and liner crumbs from the head area. Check that the bottle is centred under the head and that the cap does not rock as the head engages.
Weekly, clean the head guarding, photo sensor lenses and bottle stop area, then check pad screws, chuck insert screws and guide settings. Monthly, inspect the vertical slide, head bearings, coupling, servo mounting bolts and cable glands while the machine is locked out. Quarterly, compare saved recipes with current closures, back up names on the torque recipe sheet and test guard switches.
Wear parts and wear signs
The main wear item is the torque head pad. A good pad has a flat gripping face and an even contact mark. Change it when the face turns shiny, hard, cracked, swollen or cut, or when the contact ring sits off-centre. Glazing makes the head slip on smooth caps, while a torn pad can over-grip one side.
Chuck inserts, bottle clamp pads, guide wear strips and sensor brackets also need inspection. Look for oval holes, loose screws, polished guide faces, cap dust packed into corners and bottles twisting as torque is applied. Coastal plants and wash-down rooms should shorten cleaning intervals where salt air, caustic spray or sticky product residue reaches the head, slides or exposed fasteners.
Common faults and fixes
Under-torqued caps with the correct recipe usually point to a glazed pad, cap dust on the contact face or a bottle sitting low on the conveyor. Clean the pad and cap path, check bottle height under the head, then run a short set of torque readings. If slip returns, fit a fresh pad and record the cap batch.
Over-torqued caps after a changeover often come from the wrong saved recipe, a closure from another supplier or an unlogged setting edit. Load the named recipe for that SKU, test bottles at line speed and update the recipe sheet. If the head stalls or trips, clear debris from the chuck, inspect the coupling and vertical slide, then reset.
Cross-threaded caps, skew caps and scuffed cap skirts usually point to cap presentation and bottle control. Re-centre the guides, check bottle stop timing, confirm the cap is seated before the head turns and remove damaged caps from the chute or hand-feed area. After a power cut, follow the fixed sequence in the power-cut restart guide.
Isolation and visit preparation
Before anyone opens a guard, stop the infeed, clear bottles from the station, isolate at the main isolator, lock and tag it, then confirm the HMI and servo drive have powered down. Press start once after isolation to prove the machine cannot move. If compressed air is fitted to stops or clamps, shut the air valve and bleed stored pressure.
Before a technician visit, send a message through our contact form with the model, serial number if visible, line speed in bpm, cap type, bottle size, recipe name, set torque, actual readings, fault message and photos of the pad. Add a short video of the symptom at slow speed if safe to film. Spares can be planned with Bheki Msimang, with collections through the counter in Meadowdale Industrial, Germiston.
What our Bottle Sealing customers say
Verified Google reviews
