Service

Foil & Die Kit service

Care cadence, spares, and what to send us before a visit.

Foil & Die Kit service

A Foil & Die Kit earns its keep during neck-size changeovers on induction-sealed packs. The service work is hands-on: clean die pockets, sound cutting edges, flat sealing pads and the right wad against the right neck finish. When the kit is looked after, first-off samples settle faster and setters spend less time chasing leaks caused by dirty or worn change parts.

Care cadence on the line

Each shift, brush out foil dust, liner crumbs and cap debris before the next size is loaded. Wipe the die face with a lint-free cloth and confirm the marked die against the neck finish on the job card. At the end of the run, return each die to its marked position and record any pad change against the batch.

Weekly, inspect all regular neck sizes under bright light. Look for nicks on cutting lips, brown liner build-up, sticky adhesive smears and pad faces that have gone shiny. Monthly, check storage pockets, fasteners and die markings. Quarterly, compare the kit against the plant’s foil neck chart and order worn pads ahead of campaign work.

Wear parts and what wear looks like

The sealing pads take the most punishment. Replace a pad when it shows cuts, hard glazed patches, a permanent bottle-land ring, uneven compression or a corner lifting away from its carrier. A tired pad can look fair on the bench, then fail once cap torque presses the wad against the land.

Dies need attention when the cut edge produces whiskers, crescent-shaped scuff marks or oval wads. A chipped lip can pull aluminium and leave slivers in the cap. Corrosion marks in a pocket can transfer dirt onto a clean wad. Polish light residue with a soft cloth; burrs, dents and chipped edges call for replacement.

Common faults and fixes

Foil sitting off-centre usually points to the wrong die loaded, a die seated out of square or a wad that has shifted during handling. Stop, confirm the neck size, clean the pocket and reload the correct die. Ragged foil edges point to a dull or chipped cutting lip. Change the die and keep samples for the service note.

A weak seal on one side of the mouth often comes from a compressed pad, cap torque scatter or product on the bottle land. Fit a fresh pad, clean the land on test bottles and run a short check using the plant’s seal check card. Random leaks after changeover often trace back to mixed wad stock; quarantine open bags and restart with labelled material.

Isolation and visit details

Before anyone opens a guard near the kit change area, stop the conveyor and induction sealer through the site stop sequence, isolate the mains supply, lock out the feed where the capper or conveyor can start, and prove no movement at the belt. If the guarded cell includes pneumatic cap handling, isolate and vent that air supply. Wait for hot surfaces around the sealing area to cool.

Send a message through our contact form before a technician visit or counter handover in Meadowdale Industrial, Germiston. Include neck size, die size, foil wad type, cap supplier, bottle material, product, cap torque setting, photos of the faulty seal and when the fault started. For foil and die support see Tasneem Latief; for service routing see Bheki Msimang.

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston

What our Bottle Sealing customers say

Verified Google reviews