Foil & Die Kit specs
The Foil & Die Kit sets up induction foil wads for 28, 33, 38 and 45 mm bottle necks. Induction sealing bonds an aluminium liner to the bottle land under a closed cap. Start from the cap finish: select the marked die, match the wad to the closure pocket, and keep the other sizes separated.
Read the spec figures on the floor
The rate entry is changeovers on demand. The kit has no running speed of its own; after the die and wad are matched, production pace comes from the induction sealer. On full lines, pair the kit with the Seal Induction Pro after the closure and liner are proven; for benchtop checks up to 25 bpm, use the Seal Induction Compact.
The power and utility entry is no separate utility. There is no plug, air, steam or water connection for the Foil & Die Kit. Prepare the site by clearing a dry changeover space, wiping cap contact surfaces, checking wad sleeves before opening them, and placing the marked foil tray beside the line.
The neck figures are format sizes, not litre sizes. A 28 mm neck calls for 28 mm tooling when the cap finish and liner pocket match. Use 33, 38 and 45 mm the same way. If the cap bore or liner recess changes, check against the foil neck chart.
Fit the die, wad and closure
Use a clean production bottle, the cap for that SKU and the foil wad for the run. Seat the wad flat inside the cap, with no curled edge, trapped dust or old material. Offer the die to the closure finish and confirm that the foil face covers the bottle land without entering the thread start.
Most fit faults show early. A liner that drops out points to a wad or cap-pocket mismatch. A folded foil edge can create a leak path. A wad that sits short of the land can look sound through the closure, then fail on opening or squeeze testing.
Set first values and run samples
Start from the last accepted record for that neck, cap and wad: cap torque, induction setting, sealer head position and belt speed. If there is no record, begin low and raise heat in small steps while holding torque steady, so the next adjustment has a clear cause.
Run a short sample set with filled production bottles and caps applied by the line capper. Mark each group by setting number. After sealing, open the samples and peel the foil. Look for an even bond ring on the land, no scorched centre, no dry crescent, and no foil dragged sideways by the thread.
Accept, record and size the next job
Acceptance comes from the bottle. Check cap torque at start-up and after the sample set. Peel samples from across the lane, inspect the land, then run the plant’s leak check. Common rejects are loose torque, dirty mouths, oval necks, mixed wad sizes, overheated foil, underheated edges and an unchecked cap change.
At handover, write down neck size, cap reference, wad reference or lot, die mark, tray position, cap torque, induction setting, sealer head position, belt speed, sample count and pass or reject notes. The handoff template turns those settings into a repeatable start-up record when the same 28, 33, 38 or 45 mm job returns.
For sizing, record the neck size, cap sample, bottle sample, chosen wad if available, product type, fill temperature, closure supplier and sealer model. Add square-on photos of the bottle land and inside of the cap with a ruler in view. Those items let the die mark and wad diameter be checked before the next production changeover is booked.
| Model | Foil & Die Kit |
|---|---|
| Rate band | Die changes on demand |
| Power / utilities | No separate utility |
| Neck / format | 28, 33, 38, 45 mm trays |
Parent: Foil & Die Kit.
What our Bottle Sealing customers say
Verified Google reviews
