Service

Manual Hand Sealer service

Care cadence, spares, and what to send us before a visit.

Manual Hand Sealer service

The Manual Hand Sealer works at hand pace where the operator brings the wand to each capped bottle. Service on this unit centres on pad condition, wand face cleanliness, cable strain and repeatable contact time. Farm stall sauces, micro-brewery trials and nutraceutical batches often change neck sizes during a week, so check the sealer before the next 20 to 45 mm cap run.

Shift, weekly, monthly and quarterly care

Each shift, wipe the wand face, pad area, handle and power unit casing after the last bottle. Clear dust from vents and place the wand on its wand stand so the lead is not pulled across caps or wet benches. Open one sample, inspect the foil edge, feel the liner release and invert a filled bottle over a tray.

Weekly, inspect the pad under good light. Replace it when the face is glazed, cut, flattened on one side, swollen from product contact or browned from heat. Check the handpiece cable, plug top and strain relief for nicks, hard bends and loose clamping. Monthly, tighten external fasteners, clean fan grilles with dry air and compare the job sheet setting with the cap in use.

Quarterly, plan a service window for the handpiece lead, face plate, cooling fan noise, control knob feel and earth continuity. Sites sealing near vinegar, brine, coastal air or dusty powders should wipe exposed screws and casing edges more often. Keep a spare pad, plug lead and fastener set with the machine, then record checks on a seal check card.

Safe isolation before opening the unit

Before anyone opens a guard, cover or casing, stop sealing, switch the unit off, unplug it from the wall socket and place the plug where the person doing the work can see it. Tag the plug, let the wand and power unit cool, then remove filled bottles, loose caps and spilled product from the bench. After a power cut, follow the power-cut restart guide.

Common faults and shop-floor fixes

A foil that lifts on one side usually points to a low pad corner, tilted wand or uneven hand pressure. Fit a fresh pad, square the wand to the cap and use the same dwell count on five bottles. If the full foil stays loose, confirm that the cap contains the correct aluminium liner and that the closure batch matches the bottle neck finish.

Scorched caps, wrinkled bottle lands or a burnt smell point to too much power, too long on the cap or repeated attempts on the same bottle. Reduce the setting, shorten the dwell count and discard damaged caps from the trial. If the unit cuts out after a long run, clean blocked vents, let the power unit cool and listen for fan noise on restart.

A seal that changes when the cable is moved points to a damaged handpiece lead or strained relief clamp. Remove the unit from production and book a lead inspection before the next paid batch. A good seal on one cap size and poor results on another often comes back to liner choice or wad diameter; use the Foil & Die Kit when cap families change.

What to email before a technician visit

Send a message through our contact form with the machine name, neck size in mm, cap supplier reference, foil liner type, power setting, contact time, batch size and the exact symptom. Add photos of the wand face, pad, cap underside, sealed foil and any error light. Include whether the fault appears from cold start, after a power cut or only after a long run.

Send the site address, access notes and the name of the person who will hand over the machine. The counter is in Meadowdale Industrial, Germiston; these notes guide pad, lead and handpiece selection. For route planning, contact Bheki Msimang beforehand.

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston

What our Bottle Sealing customers say

Verified Google reviews