Manual Hand Sealer specs
Use the Manual Hand Sealer specifications as a start-up procedure for a packing table. This portable induction wand suits farm stalls, micro-breweries and trial packs where capped bottles move in trays rather than on a conveyor. The rate line means hand paced: the operator caps one bottle, places the wand squarely, waits for the timed seal, then moves the bottle to the accepted tray. Output depends on cap preparation, reach and a steady hand rhythm.
Set the table, power and working reach
Put the control unit where the operator can see the timer and reach the capped bottles without pulling the lead across open product or loose caps. The power figure on the rating plate tells maintenance which mains point to allocate, so check the plug point before the run starts. Keep the control box off wet worktops and away from rinse water, syrup splash or chemical drips.
Park the wand between seals on a wand stand beside the control unit. The operator needs separate spaces for unsealed bottles, rejected samples and accepted bottles. Mechanical fit starts with the closure: a cap that rocks, cross-threads or sits loose will give patchy bonding. The wand face must sit squarely over the cap area without the operator using downward force to correct a bad pack.
Check the 20 to 45 mm neck range against the pack
The 20 to 45 mm neck range is the working window for this hand sealer. Measure the neck finish, cap liner fit and bottle land before setting the timer. The foil wad should cover the sealing land without folding up the wall or sitting short on one side. For 28, 33, 38 and 45 mm work, the Foil & Die Kit keeps trial cuts consistent between operators.
Most failures on this machine show up as pack preparation faults. Wet product on the land, powder dust, off-centre foil, low cap torque or over-tight caps can all produce a weak ring. Excess dwell shows as a scorched liner edge, a domed wad, a softened closure top or a cap surface that no longer matches the approved sample. Too little time gives a bond that opens early when the cap is removed. Soft oval necks need gentle handling and a flat standing surface.
Make the first settings and run the sample tray
Start with filled bottles from the actual batch, capped to the normal torque and standing on the same table surface planned for packing. Use the manual’s starting point for that neck, then adjust timer or power one step at a time. Place the wand squarely, hold it steady for the full timed cycle and lift cleanly. Do not press the bottle neck to make the pack look straight.
Run a small tray before releasing production. Open samples that represent the shift, then inspect the bonded ring, foil face and any seepage around the land according to the product spec. Record the timer, power setting, cap, foil, operator and result on a seal check card. If one side peels early, check wand placement, cap squareness and table height before increasing energy.
Handover notes and sizing information
For shift handover, record the container resin, measured finish, closure style, liner batch if known, die size, timer, power setting, operator grip and accepted sample result. Add a photo of the finished seal face and the opened liner so the next shift has a reference. The handoff template suits short-run work where packing, QA and maintenance share one hand sealer.
For a sizing check, send capped sample packs, spare liners, neck measurements, fill product notes, expected batch count and a photo of the operator’s table layout through our contact form. If hand-paced sealing becomes the slow point, compare the pack against Seal Induction Compact for benchtop short runs.
| Model | Manual Hand Sealer |
|---|---|
| Rate band | Hand paced |
| Power / utilities | Handheld coil |
| Neck / format | 20 to 45 mm |
Back to Manual Hand Sealer.
What our Bottle Sealing customers say
Verified Google reviews
