Service

Seal Induction Compact service

Care cadence, spares, and what to send us before a visit.

Seal Induction Compact service

The Seal Induction Compact is serviced as a bench machine that is moved, reset and cleaned between short batches. The service focus is the induction head face, cap support, height setting and foil wad match. Near the Compact’s 25 bpm bench pace, a small cap height change shows up fast in seal samples.

The working space from the head face to the cap top sets how strongly the induction field heats the aluminium liner. A wider gap gives weaker heating; a tight gap can overheat the cap area. Correct closing torque presses the foil wad evenly onto the mouth finish while the seal layer melts and sets. Use the coil gap guide when cap height or liner stack changes.

Care cadence for the Compact

Each shift, wipe the head face, cap path and bench fixture with a soft dry cloth. Check the power lead, plug, start switch and cooling vents. Confirm bottle material, neck size, cap and liner against the batch sheet before first-off samples. Record power, dwell and head height for the next setter.

Weekly, clean dust from the vents and check that the height clamp locks without slipping. Monthly, after safe isolation, an authorised technician checks fan noise, earth continuity, terminal tightness and cable strain relief. Quarterly, plan a bench service with spare cap pads, failed bottles, a known good liner set and neck details from the foil neck chart.

Wear parts and visible wear

The head face cover wears through cap rub, heat staining and baked-on product mist. Replace it when scratches catch a fingernail, the surface blisters, or a cleaned face still shows low shiny patches. Cap nest pads wear as polished grooves, cap wobble or a bottle that enters square but exits skew. Height knobs need attention when the measured gap drifts.

Cooling parts show trouble through a rough fan note, warm casing or dust mats on the grille. Start switches and foot controls show wear as double triggers, delayed starts or dead spots in the press. Foil wad condition must be checked with the machine: crushed edges, mixed liner types or wrong diameter can mimic a Compact fault. Match wads through the Foil & Die Kit.

Fault symptoms and fixes

A dry liner lift with little plastic transfer usually points to a wide head gap, short dwell, low output, low cap torque or a liner facing the wrong way. Reset the gap, tighten cap control and run a fresh sample. A crescent-shaped bond often comes from a tilted cap, bowed bottle land or a cap nest worn harder on one side.

A burnt odour, wrinkled liner or softened cap shows that the seal zone has taken more energy than the closure can handle. Raise the head slightly, shorten dwell or reduce output, then test after the cap cools. Intermittent good and bad bottles often trace back to mixed cap heights, residue on the neck finish or uneven hand presentation. Clean the necks, sort caps and hold a steady bench rhythm.

Isolation and visit notes

Before anyone opens a guard or cover, stop the batch, switch the Compact off, unplug it at the wall and keep the plug under the technician’s control. Let the head face and internal parts cool, then clear bottles, loose caps and liners from the bench. Stored electrical energy and hot surfaces are treated as present until proved safe.

For a Compact service assessment, send the model, container resin, measured neck finish, closure style, foil wad diameter, product description, last passing settings and the exact reject pattern through our contact form. Include photos of the head face, cap top and failed seal, plus a short cycle video where possible. Cap pads, head face parts and test records can then be matched to the fault pattern and noted on the seal check card.

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston

What our Bottle Sealing customers say

Verified Google reviews