Service

Steam Tunnel L service

Care cadence, spares, and what to send us before a visit.

Steam Tunnel L service

The Steam Tunnel L works on large-neck jerry and gallon containers where the sleeve must shrink cleanly around a broad cap, shoulder and handle recess. Service work starts with steam pressure, dwell through the hood, sleeve fit, sleeve height and bottle pitch. On chemical and oil lines, small changes in spacing or cap shape show up as loose shoulders, wet handle pockets or a tear line in the wrong place.

Care cadence for the Steam Tunnel L

At each shift start, warm the tunnel, confirm stable steam pressure, check drain flow, then pass retained containers through the hood. Look for sleeve pull-down at the cap shoulder, tear perforation position, wet beads in jerry handle recesses and scuffing from side guides. Weekly, clean sleeve residue from steam pads and guide faces, wipe the hood lip and check that drain traps discharge cleanly.

Monthly service should cover hood alignment, belt tracking, guide wear, steam hose condition, trap cleaning and sleeve height against the current container. Quarterly, inspect gaskets and pads with spares ready, then record steam pressure, dwell setting, container pitch and sleeve lay-flat for each format. The steam start guide suits restarts after shutdowns, product changeovers and power interruptions.

Wear parts and wear signs

The hood gasket is the first part to inspect when drying becomes untidy. A good gasket sits even on the hood edge; a worn one looks shiny, flattened, cracked or stained where steam has been leaking. Steam pads should be clean, square and free of hard residue. Blocked pad faces leave one side of the sleeve loose. Drain traps that stick closed leave condensate in the base.

Conveyor and guide wear also shows on the sleeve. Grooved guide faces can twist a jerry as it enters the steam zone, so the tear line can land beside the cap rib instead of facing the operator. A tracking belt can make pitch uneven, giving one container longer dwell than the next. Keep a steam hood gasket set, steam pads, drain trap seals and guide wear strips ready for planned stops.

Fault symptoms, causes and fixes

A loose band around the cap shoulder calls for checks on steam pressure, time under the hood, pad cleanliness and the match between sleeve width and the actual neck-and-cap profile. Restore the pressure setting, slow the passage through the hood if the run permits, clean the pads and confirm the sleeve size. If the sleeve is tight at the top but loose below the cap, check sleeve height.

Water sitting in jerry handle recesses points to condensate control. Clear the drain traps, check that the base drains fall away from the hood, and inspect the hood gasket for leaks that push wet steam into the wrong area. A wrinkled or scorched skirt points to excessive dwell, high local steam contact or sleeve height sitting too low. A hidden tear perforation points to sleeve placement, guide position or uneven bottle pitch.

Safe isolation before opening a guard

Before anyone opens a Steam Tunnel L guard, stop the conveyor, shut the steam valve, lock out the local electrical isolator, tag both points, then vent pressure from the tunnel side. Wait for the hood, pads and drain area to cool before hands go inside. Confirm zero belt movement and no live steam at the chamber. Guards come off after those checks.

What to email before a technician visit

For a Steam Tunnel L visit, send a message through our contact form with the container capacity, neck and cap measurements, sleeve lay-flat, sleeve height, sleeve material, tear perforation position, current steam pressure, line speed and bottle pitch. Add photos of the hood gasket, steam pads, drain traps, wet handle recesses and the finished sleeve. Include the site address, access window and last cleaning date; Marnus Esterhuizen or Bheki Msimang can plan parts from Meadowdale Industrial, Germiston.

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston

What our Bottle Sealing customers say

Verified Google reviews