Service

Steam Tunnel S service

Care cadence, spares, and what to send us before a visit.

Steam Tunnel S service

Steam Tunnel S service keeps the compact steam chamber steady on narrow-mouth bottles where the sleeve must finish square on the cap and neck. A good set-up gives even shrink, a clean tear perforation line and dry necks at the exit. The service check works through the steam setting, time in the chamber, sleeve width, cut height, bottle spacing, drain path and exit air wipe.

Book attention on the Steam Tunnel S when creases, loose bands, split perforations or wet caps repeat across a batch. Those faults usually come from drift in steam delivery, sleeve sizing, drainage or warm-up practice. A technician works from the bottle entry through the chamber, then checks the finished sleeve at the outfeed.

Service cadence for production days

Each shift, warm the tunnel fully, confirm steady steam pressure, check that condensate drains are open and inspect the first bottles out of the chamber. Record sleeve height, sleeve lay-flat width, bottle pitch and speed for the SKU. After power or steam loss, recheck shrink finish before feeding full production.

Weekly, isolate and cool the tunnel, then wipe the chamber, clear drain hoses and remove visible scale from steam outlets. Monthly, inspect the hood seal, chamber curtains, guide contact points and drying position. Quarterly, plan a deeper clean, check latch pressure, replace tired hoses and keep the right gasket set ready for shutdown.

Wear parts and wear signs

The steam hood seal is the first service part to watch. A good seal sits evenly against the chamber edge. A worn one looks flat, glossy, cracked or pinched at the corners. Steam then escapes from one side, cutting dwell and leaving a loose or wrinkled patch on the sleeve.

Condensate hoses and fittings wear from heat, water quality and cleaning chemicals. Replace hoses that are brittle, cloudy, swollen or kinked. Steam outlets with scale give a broken shrink pattern. Guides with shiny flats can turn bottles as they enter, so the tear line no longer faces the operator and the sleeve finishes on a slant.

Fault symptoms, cause and fix

Creases on one side usually mean uneven steam, a leaking hood seal or blocked outlets. Isolate, cool, open the guard, clean the outlet area and fit a fresh seal if the old one has flattened. Bring the tunnel back to temperature and test several bottles at the same pitch before releasing the batch.

A sleeve tight at the top and loose lower down points to short dwell, poor sleeve height or lay-flat width that is wrong for the neck. Confirm the sleeve dimensions against the job card, then adjust pitch and exposure in small steps. Use the band sleeve size guide during changeovers to match lay-flat width to the cap and neck.

Split tear perforations or pinched bands point to too much heat exposure, a sleeve sitting too tight before shrink or steam pressure set too high for the bottle. Reduce exposure gradually, confirm the perforation direction and check that bottles are not touching in the chamber. Wet necks point to blocked drains, poor hose fall or weak exit drying.

Isolation and job notes

For guard access, stop the bottle infeed, shut the steam feed, lock out the machine supply under the plant programme and wait for the pressure to bleed down. Give the chamber time to cool before removing covers or hoses. Treat drained water as hot condensate, then restart with a short sleeve run and inspect the tear line, neck dryness and band height.

For a service visit, send us the model name, plant location, current speed, bottle photos, sleeve height, lay-flat width, cap diameter, bottle pitch, steam setting, drain layout and exit fault. Marnus Esterhuizen can review the sleeve behaviour and steam symptoms before site work so the visit starts with the right gaskets, hoses and hood parts.

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston

What our Bottle Sealing customers say

Verified Google reviews