Support

FAQ

Common questions on induction, bands, and commissioning.

Support FAQ

For an FAQ answer, send a message through our contact form with the pack facts that change the setting: bottle material, neck finish, cap type, liner insert, sleeve size, fill condition, target pack rate, conveyor width, open line space and the reject pattern seen on shift. Use the Meadowdale Industrial, Germiston counter for measured sample checks, co-pack discussions and consumable collections linked to those samples. From that first pack set, the team can separate a cap torque fault from a sealing fault and map the next trial step.

Which sealer suits my bottle, and what must I send first?

For PET or HDPE bottles with aluminium foil liners, the choice starts with neck finish, cap type, fill temperature, cap torque and pack rate. Short R&D and contract batches are often checked on the benchtop Seal Induction Compact, rated up to 25 bpm, while continuous production runs are reviewed against the Seal Induction Pro with the plant’s conveyor layout and shift target in mind. Send three to six capped samples, loose caps, liner details, product type, leak complaint photos and the line direction, so the first answer is based on your pack, not a guess.

Can one line run both a sleeve and an induction foil?

Yes, many plants run a tamper sleeve on the neck and a foil liner under the cap, but the cell must be set out in the right order with enough straight conveyor, drainage and access. Sleeves need steam contact, bottle pitch and drying time; foils need cap pressure and a steady bottle presentation under the induction head. High-volume dual-lane sleeve work can be reviewed against the Band Shrink 240, rated at 120 bpm per lane, while the Steam Tunnel L is the wide-mouth tunnel for jerrycans and gallon packs.

Can we run trials at Meadowdale or at a mall counter?

Meadowdale trials suit physical pack checks, sleeve sizing, foil wad matching and brief sign-off with samples on the counter. Bring clean bottles, filled samples where safe, caps from the actual batch, sleeves or artwork dimensions and any failed packs from production. Mall counters are appointment-based and booked by email; they suit brief capture, sample transfer and meeting notes for plants outside Germiston, not full steam runs or production-style commissioning.

What happens during commissioning or a service visit?

On site, the technician first watches the current line run, checks capper position, conveyor tracking, bottle spacing, guarding access, air supply where fitted and electrical points. The machine is then positioned, rails are set, guides are centred, reject timing is checked where fitted, and the setter is shown the start-up and changeover sequence. Afterward, the plant has recorded settings, sample check notes, fault symptoms to watch and a clear handover for production and maintenance.

Which spares, settings and restart notes should maintenance keep?

Maintenance should keep wear parts and line notes with the machine, not in a general store where changeover crews cannot find them. A Spares & Care Kit groups common parts with a service card for the plant team, while torque recipes, sleeve sizes and seal check cards should sit with the setter pack. Common faults include loose caps, skew sleeves, wet bottles after steam, missed rejects, scorched liners and leaks that trace back to cap pressure rather than the sealer.

After a power cut, restart from a known state: stop feed, clear bottles from the sealer zone, confirm caps are tight, let steam equipment reach a stable run condition, run sample packs, then release production. The power-cut restart guide gives setters a short sequence for power returns, nuisance trips and warm restarts, so the line comes back with checked samples rather than mixed product in the first crate.

Talk to the sealing counter

Contact form · Meadowdale Industrial, Germiston