Band Shrink 120 service
Band Shrink 120 service is about steam, sleeve control and repeatable tamper bands on the customer’s own bottle. The Band Shrink 120 should be logged by neck finish, cap shape, sleeve lay-flat, cut height, tear-strip position, bottle spacing and the steam setting proven on that SKU. Keep one record per format so setters can return to a known dwell after changeover.
Service cadence on the Band Shrink 120
Each shift, clear loose sleeve offcuts from the tray, wipe cap contact pads, clean the side guides and check that rails have not moved during washdown or changeover. Confirm steam pressure during warm-up, remove standing condensate, keep sleeve stacks dry and run the first containers slowly enough to see the band settle. The tear perforation must land where the operator can grip it, with the sleeve sitting square on the cap before steam pulls it down.
Weekly, clean accessible steam nozzles, wipe sensor faces, inspect drain paths and look for mineral marks around hoses, clamps and hood seals. After weekend stops or boiler interruptions, follow the steam start guide sequence for pressure build, condensate clearing, hot-zone warm-up and first-pack sign-off.
Monthly, inspect shrink pads, guide faces, tray edges, belt tracking, bottle pitch hardware and fasteners near the hot zone. Quarterly, strip and clean the nozzle bank more deeply, check drain trap action, listen for bearing noise and compare sleeve sizing against current packs. Hard-water sites should move nozzle cleaning earlier when shrink becomes uneven.
Wear parts and visible wear
Shrink pads wear where they touch the sleeve at the neck. Replace them when the face is glazed, cracked, thinned, grooved or sticky, because those marks show up as loose band edges and ragged tamper tears. Keep the sleeve feed tray and neck guides smooth, level and free of burrs; a hooked tray lip can tip the band before it reaches the hot zone.
Steam wear shows in the shrink pattern. Blocked nozzles give one tight side and one loose side. Hardened seals show vapour leaks and white scale marks around the hood. A weak drain path gives wet caps and shoulder droplets. Belt wear appears as frayed edges, shiny patches, wandering tracking or bottle pitch drift.
Fault symptoms and fixes
Loose bands at the back of the cap usually come from weak steam at the nozzle bank, too little time in the hot zone, fouled nozzle slots or necks travelling too close together. Bring pressure back to the recorded setting, clean the nozzles, slow the belt pace for that SKU and reset pitch so each neck receives steam evenly.
Wrinkled or twisted sleeves usually come from wrong lay-flat width, sleeve height set too low or guides out of square. Match the current pack to the band sleeve size guide, check that the band sits level before steam, then move the guides until the sleeve enters the chamber without rubbing.
Ragged tear perforations come from worn pads, a perforation line trapped under the cap bead or uneven shrink around the neck. Fit fresh pads, raise or lower the sleeve to the agreed height and run a short pack check. Wet caps after the chamber point to condensate carry-over, cold start or drain restriction.
Safe isolation and visit notes
Before anyone opens a Band Shrink 120 guard, stop the line, isolate and lock the electrical supply, close the steam valve, vent pressure, drain condensate and wait for hot metal, hoses and hood parts to cool. Confirm zero pressure at the gauge. Refit guards and test interlocks before production speed.
For a steam-band service booking, send clear photos, a short video of bottles entering and exiting the hot zone, sleeve grade, cut height, lay-flat width, neck diameter, cap style, steam pressure, product town and fault history through our contact form. Marnus Esterhuizen can use those details to prepare pads, guides, nozzle parts or drain items for arranged collection from Meadowdale Industrial, Germiston.
What our Bottle Sealing customers say
Verified Google reviews
