Seal Induction Pro specs
Use the Seal Induction Pro rating as a production target, not a sticker number. The rated 120 bottle-a-minute output is reached when capped PET or HDPE packs pass under the coil in a square, settled, repeatable line. If torque varies, the conveyor surges, or guides let the bottle wander, mixed seals appear before that rate is reached.
The 3.5 kW induction head supplies heat for the aluminium foil liner. The head energises the foil through the cap, and the liner’s sealing face must press evenly onto the bottle land during that heating cycle. The 28 to 38 mm neck band covers common South African cap sizes such as 28, 33 and 38 mm when the cap, wad and land match.
Prepare the bay and utilities
Position the sealer where capped bottles have settled into single file with straight conveyor through the coil area. Provide an electrical supply sized for the 3.5 kW head and route cables away from washdown paths, pallet movement and operator walkways. Bring the sample bottle, cap and foil wad to planning so the centre line and head height match the actual pack.
Check conveyor height, guide wear and bottle stability before the head is mounted. Tall HDPE packs often need longer guide contact than short PET bottles. If the bay needs repeatable height marks, mount the head on the coil mount and lock the guides on a rail section that can be reset after changeover.
Set the first values
Set the induction head face parallel to the cap tops, then measure the air gap from the cap crown to the coil face. That gap controls how much heating energy reaches the foil. Too wide a gap gives slow heating and weak edge bonding; too tight a gap can overheat the cap and neck area. Use the same measuring point every time.
List the neck finish, cap diameter, liner type and bottle material before changing output settings. Centre the bottle path under the head, run dry samples through by hand and look for shoulder rub, cap scuffing or guide pinch. Where torque capping is part of the cell, confirm the recipe upstream on the Cap Torque Station.
Run samples and accept the window
Start with a short sample at low speed, then move towards the planned production rate in small steps. Adjust only one variable per trial, whether it is head height, output level or conveyor speed. Mark each sample group with its setting and let the bottles cool before testing, because a hot liner can look bonded while the edge has not settled onto the land.
Acceptance checks should match the pack. Lift the liner edge and read the tear pattern on the land, inspect the full circumference for dry sections, and invert or squeeze filled samples where the product permits. Crescent burns usually point to off-centre travel, one-sided seals to a tilted head, leaks to low torque, and wrinkled foil to a poor liner seat.
Write down the handover and size the job
At handover, record the pack details in full: material, neck finish, cap code, foil wad description, torque setting, coil gap, output level, conveyor speed and accepted sample numbers. Photograph the head position and guide marks with a ruler in the frame. The handoff template gives maintenance and production the same reference after a supplier change, belt change or shift change.
For Seal Induction Pro sizing, send a message through our contact form with bottle height and width, neck finish, cap diameter, liner specification, target bottle rate, fill temperature, product type, conveyor width and available straight length. If the liner choice is open, use the foil neck chart and include sample caps and bottles so the first trial starts with the correct neck and wad combination.
| Model | Seal Induction Pro |
|---|---|
| Rate band | Up to 120 bpm |
| Power / utilities | 3.5 kW coil |
| Neck / format | 28 to 38 mm common SA necks |
Parent: Seal Induction Pro.
What our Bottle Sealing customers say
Verified Google reviews
