2026-09-21
Handoff note to the line lead
What our team should receive so commissioning does not restart from zero.
Handoff note to the line lead
A seal handoff should give the next line lead the working pack, not a memory of the commissioning run. Write the bottle, neck finish, cap, liner or sleeve, actual bpm, passed check and setting changed. When that note is missing, the shift often repeats trials, burns samples or moves a good setting away from the last passed pack. Add a photo of the passed pack and the rejected fault sample so the next setter sees the cap seat, liner mark or sleeve position that was accepted.
Why the record gets lost on local floors
Local packing rooms can move from sauce to chemicals to contract batches between stoppages and restarts in the same week. A sauce job may leave the conveyor, then a household chemical bottle takes its place with another neck, cap and closure feel. The note must travel with the job card, not with one setter. Start from the commissioning run and record the last pack that passed on the plant’s own capper, conveyor, guides and reject timing.
Induction handoff, step by step
Begin with pack identity: product name, container resin, neck size, closure style and the exact liner fitted. Write necks as 28 mm, 33 mm, 38 mm or 45 mm so the next person can match the job without interpretation. For a continuous run on Seal Induction Pro, record the actual bpm used, controller setting that passed, sealer head lift position, belt speed and cap torque recipe. Add the person who signed off the last peel and leak result.
Put consumables and tooling directly below the machine settings. If a Foil & Die Kit was used, record the die fitted, foil wad description, liner side presented to the cap and any die change made during the trial. Common handoff failures are scorched liners, edge lift, a dry crescent at the rim and caps tightened after the passed sample instead of before it.
Sleeve and steam handoff, step by step
For a tamper sleeve job, write the sleeve material, height, lay-flat width, tear line direction, container spacing, steam valve position and time through the heated chamber used for the passed run. On Band Shrink 120, the next setter needs the lane set-up, feed tray position and where the sleeve sat on the cap shoulder during sign-off. For large-opening jerry cans and gallon containers, add the chamber notes from Steam Tunnel L, including wet labels, condensate at exit and drying point.
Sleeve failures usually show as a high back edge, twisted perforation, cloudy print after steam or a band that rides above the tamper bead. Those faults are hard to trace if the note only says “steam adjusted”. Write what changed: pressure moved up, dwell moved down, guides opened, feed tray shifted or bottle pitch corrected. That wording tells maintenance whether to inspect steam supply, worn guides, tray geometry or upstream spacing.
Checks, spares and a worked example
Keep QA and maintenance facts in the same handoff. Record sample count, peel wording, leak result, photo reference, rejected bottles and the time the last good pack came off the conveyor. If Seal Inspect Vision was active, add camera position, light bar level, trigger timing and air-blast reject delay. If a belt, sensor, head, gasket or torque pad was changed, name the item and where the old part was placed.
A typical edible-oil changeover note might read: 38 mm HDPE bottle, EO38 cap torque recipe, foil wad matched to 38 mm die, line run at 92 bpm after capper adjustment, controller setting and sealer head lift position as per commissioning label, three passed peel samples, no leaks in bath, reject timing tested with a missing-liner cap, spare sensor fitted at the infeed. That gives the next line lead a start point, not a guessing session.
What our Bottle Sealing customers say
Verified Google reviews
