Support
Service visits
Book a service hour for coil or steam tuning.
Service
Service visits start with a clear request, not a guess on the production floor. For a service booking, send us the model name, bottle or jar size, closure type, liner or sleeve detail, current line speed, town, and the fault or changeover problem. Attach short videos from the infeed, sealing area and outfeed, plus photos of rejected packs from the same batch.
Send the last good settings if the plant has them, together with cap torque readings, sleeve height, recent part changes and any operator notes from the shift. For induction work on Seal Induction Pro, include the neck finish and foil wad type. For steam work, send the sleeve lay-flat width, perforation position and visible finish fault.
Booking the right type of visit
A planned visit suits a format change, export week, maintenance stop or new operator handover. The service booking is then built around running stock, trained setters and space at the conveyor. The plant prepares sample closures, filled packs, spare sleeves or liners, and access to the electrical panel, steam supply and reject area where fitted.
A breakdown visit starts with symptom sorting. No seal, patchy bond, scorched liner, sleeve twist, wet neck band, poor perforation position, reject build-up and intermittent stops are treated as separate faults. The request is checked against photos, video and current settings so the technician arrives with the right test method and likely wear parts listed for inspection.
What happens at the counter or on site
The Meadowdale Industrial, Germiston counter area gives the team a quiet place to inspect service samples, closures and removed parts before a line visit is booked. Bring failed packs, good packs, caps, liners, sleeves and any removed wear part. Counter work is suited to pre-checking a service request, confirming whether the issue follows the pack format, and preparing a clean job brief for the technician.
On site, the technician watches the line run before changing settings. The check starts at the capper or sleeve feed, then follows the pack through the sealer, tunnel or reject point. The line setter stays with the technician so every change is linked to a bottle sample, a setting value and a visible result rather than a workshop theory.
Checks made during the service
Induction checks cover cap application, cap torque, induction head height, conveyor presentation, whether the liner sits flat on the sealing land, power setting and sample results from the running batch. The technician records which change corrected the failure mode, whether the fault came from setup, product variation or wear, and which setting the setter must return to after cleaning or power-cut recovery.
For sleeve equipment, service checks cover sleeve feed, bottle pitch, steam pressure, dwell through the chamber, drain-off, neck finish and drying after the tunnel. On Band Shrink 240, service notes treat the machine as two lanes at 120 bpm each, with sleeve feed and reject causes recorded per side. On Steam Tunnel L, jerry cans and gallon containers with wide openings are checked for steam coverage across broad shoulders, handle-side shadowing and neck-band finish.
What the plant receives afterwards
After the visit, the plant receives a job card with the fault reported, tests run, settings changed, samples checked, parts inspected and operator notes. The card is written for supervisors and maintenance leads, with plain action lines such as replace a worn steam hood seal, reset bottle spacing, clean a sensor face or change a damaged torque head pad.
The job card is paired with a parts list and a suggested next service date based on the plant’s use pattern and changeover load. Where the line needs better shift records, the technician can reference the handoff template, seal check card or steam start guide so operators record the same details on every run.
