Seal Inspect Vision specs
On a sauce, edible oil, syrup or export line, the Seal Inspect Vision is fitted where capped bottles are still in single file. The station uses a camera, LED light bar and air-blast reject to read the cap area for foil presence and seal appearance, then send any suspect bottle out of the pack stream. The floor aim is plain: accepted bottles keep moving, suspect bottles leave the line cleanly.
The rate entry, “match line rate”, is read against the conveyor running on site. During sizing, bottle pitch, belt speed, cap diameter and reject distance are measured so the camera trigger and air pulse match the plant’s flow. The power entry, “LED + camera”, covers the light source and imaging unit, so site prep calls for clean electrical supply, protected cable routing and an operator stop point within reach.
Site preparation and utilities
Prepare a straight inspection section with enough bottle control for the neck to pass the same viewing position each time. Wobble, guide rub and surging after a rotary table cause nuisance rejects, so guide setting comes before vision work. The air service feeds the neck reject blast through a regulator and clean tubing. If the line is being built up, mount the sensors, guides and reject hardware on the Line Integration Rail so the inspection point can be locked to one straight section.
Mechanical fit and first settings
Mechanical fit starts with the bottle centred under the camera view, the cap top square to the lens and the LED bar angled for a repeatable cap image. The “neck / format” entry on the spec is the reject method: an air blast aimed at the neck or cap shoulder. A reject pocket catches flagged containers and keeps them out of packed product.
First settings are taken from live product. Run capped bottles with known good seals, then teach the camera the accepted cap view for that SKU. Set trigger position, exposure, inspection window, reject delay and air pulse length against the actual spacing. Cap colour, foil print, closure height and bottle shoulder shape can change the image, so each SKU gets saved notes and a short challenge run.
Sample run and acceptance checks
The sample run uses three groups: accepted bottles, bottles with no foil fitted, and bottles with a known poor seal from the day’s sealing set-up. Feed them in a marked order and watch the reject map on the screen. Accepted bottles should pass; each bad sample should reach the air blast and leave the line into the pocket. The vision reject map records the order and outcome.
Acceptance checks are done with the line crew, quality lead and maintenance lead together. They confirm that the inspection catches the agreed fault set, that reject timing holds at normal speed, and that the reject pocket is cleared before it backs up. Common sign-off faults are glare from a moved light, a dirty lens, bottles touching at the trigger, an air jet aimed too low, or a guide change after teaching.
Handover notes and sizing information
At handover, write down SKU name, cap size, closure colour, bottle height, line speed used, camera height mark, light setting, trigger setting, reject delay, air pulse setting and the test samples kept for the next shift. Add lens cleaning, air line checks and bracket lock checks to the operator routine. The handoff template and seal check card keep records in audit-ready form.
For sizing, send production-speed footage of the inspection area, photos of the cap from top and side, bottle height, cap diameter, foil style, bottle spacing, available rail length, reject space and compressed air point position through our contact form. For pack confirmation, use labelled good, no-foil and poor-seal samples so the Seal Inspect Vision can be checked against the actual closure, bottle shoulder and reject path.
| Model | Seal Inspect Vision |
|---|---|
| Rate band | Match line rate |
| Power / utilities | LED + camera |
| Neck / format | Reject air blast |
Parent: Seal Inspect Vision.
What our Bottle Sealing customers say
Verified Google reviews
