2026-08-28
Steam sleeves and cooler condensation
Keeping shrink bands neat when bottles go straight into cold rooms.
Steam sleeves and cooler condensation
Condensation on a steam-shrunk sleeve is a floor problem, not a cosmetic afterthought. Warm product exits the filler, the neck band is hit with steam, and the bottle then moves into a colder packing or storage area. Water sits under the shoulder edge, runs through the tear line, or beads on the sleeve face. The result is a wrinkled tamper band after chill-down.
South African lines see this on RTD, water, juice and sauce packs because conditions change hard between regions and shifts. Durban humidity keeps sleeves wet for longer, Cape winter pulls heat out of glass and PET quickly, and Gauteng cold-room handover can shock a warm bottle within metres. Treat steam pressure, time in the tunnel, sleeve grip, bottle spacing and the dry-off area as one running condition, then change only one item at a time.
Set the sleeve before chasing the steam
Start with the sleeve on a filled, capped bottle from the run. Measure the sleeve around the neck and shoulder, then check where the top and bottom edges sit when the cap is fully tightened. A loose sleeve traps droplets; a short sleeve climbs; a tall sleeve can fold into the shoulder radius. Record the neck diameter, sleeve cut, opening position and material against the band sleeve size guide so the next shift sets the same starting point.
Bottle pitch matters as much as heat. If bottles touch or run unevenly, one neck shields the next from steam and the sleeve shrinks more on one side. Set guides so each bottle enters square, with a repeatable gap. On a Band Shrink 120 line, confirm the sleeve feed tray presents bands straight, then watch ten bottles through the station without adjusting anything.
Tune pressure, dwell and drying in that order
Bring steam pressure up in small steps and look at the sleeve edge, not only the front panel. The band should pull evenly around the cap without a wet ridge at the lower edge. Set dwell by belt pace through the steam zone and use the slowest pace that gives full shrink without scuffing or heat marking the pack. A Steam Tunnel S suits compact narrow-mouth work.
For jerry cans, gallons and broad shoulders, the wet spot usually sits below the handle or at the shoulder corner. On Steam Tunnel L, the wide chamber gives space to direct steam across the neck and upper body without crowding large packs at the entry. After the tunnel, keep enough open run-out for droplets to break and fall before the bottle reaches a cold zone or closed carton.
Record the settings that explain the defect
A useful sleeve log lists product temperature band, bottle material, neck size, measured sleeve width, sleeve cut, opening position, bottle pitch, steam pressure, belt pace and the first place where water collects. Add the drying method used on that shift, such as open run-out, fan air or a wipe-down station. Photos should show the tunnel exit, two minutes after exit, and after cold-room entry.
Worked example from a beverage line
A typical 500 ml RTD line on a 38 mm neck showed neat bands at the steam exit, then wrinkling on the front neck panel after cartons stood near a cold-room door. The first check found the sleeve too loose at the shoulder and bottles crowding at the tunnel mouth. The setter moved to the snugger recorded lay-flat, raised the sleeve height, opened the pitch, and reduced steam pressure slightly while adding dwell.
The next run showed an even lower edge and less water held under the sleeve. The tear perforation stayed centred for hand opening, and the drying run-out gave droplets time to clear. For worn gaskets or tray alignment issues, use the steam hood seal and sleeve feed tray notes during line care. For a condensation trial, send the bottle shape, sleeve sample, running speed and tunnel symptoms through our contact form.
What our Bottle Sealing customers say
Verified Google reviews
